2023

• Herzog C., Drummer D.:
  Influence of the injection molding process on the tooth deflection of plastic gears during operation
  5th International Conference on High Performance Plastic Gears 2023 (Garching/ Munich, 13th September 2023 - 15th September 2023)
• Herzog C., Drummer D.:
  Limitations of the Check Calculation for Tooth Deformation of Plastic Gears According to Gear Design Guideline VDI 2736
  In: Polymers 15 (2023)
  ISSN: 2073-4360
  DOI: 10.3390/polym15183809
• Herzog C., Drummer D.:
  Test Rig for The In Situ Measurement of The Elastic Tooth Deflection of Plastic Gears
  In: Polymers 15 (2023), Article No.: 1732
  ISSN: 2073-4360
  DOI: 10.3390/polym15071732
• Schubert D., Rohrmoser A., Herzog C., Wolf M., Hagenah H., Merklein M., Drummer D.:
  Influence of production process-induced surface topologies at varying roughness depths on the tribological properties of polyamide steel contact
  In: Journal of Polymer Engineering 43 (2023), p. 187-197
  ISSN: 0334-6447
  DOI: 10.1515/polyeng-2022-0231

2022

• Herzog C., Wolf M., Drummer D.:
  In Situ Measured Tooth Flank Wear of Plastic Gears under Spectrum Loading
  In: Polymers 14 (2022), p. 5239
  ISSN: 2073-4360
  DOI: 10.3390/polym14235239
• Herzog C., Wolf M., Schubert D., Drummer D.:
  In situ investigation of the influence of varying load conditions on tooth deformation and wear of polymer gears
  In: Forschung Im Ingenieurwesen-Engineering Research (2022)
  ISSN: 0015-7899
  DOI: 10.1007/s10010-022-00591-1
• Schubert D., Herzog C., Drummer D.:
  In Situ Test Rig for the Measurement of the Operating Characteristics of Polymer Gears
  In: Zeitschrift Kunststofftechnik 1 (2022), p. 93-116
  ISSN: 1864-2217
  DOI: 10.3139/O999.02022022